- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Gentlemen,
I am beginner user at wiced and cypress .
I have a refrence board (BCM94343WWCD1) and installed wiced 5.2.1 .
I create the make target "snip.scan-BCM94343WWCD1 download run". compiling and downloading was successful.Unfortunately it doesn’t work. I had changed the name with"snip.scan-BCM94343WWCD1-debug download" and debug it for step. Then, I found the default . befause of the wicedfs_init funtion err,
fs_handle->readfunc funtion is NULL . But I did not know Why . I just couldn't figure out how to solve the problem .
Solved! Go to Solution.
- Labels:
-
Wifi+Bluetooth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
From SDK 5.2 onwards, you need to insert download_apps flag in your build statement to put your wifi firmware and clm blob into external flash for 4343W, 43364, 43438 platforms. Your updated build statement should look like snip.scan-BCM94343WWCD1 download download_apps run. Please check the Release Notes: WICED Studio 6.0.0 for further information on this.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
From SDK 5.2 onwards, you need to insert download_apps flag in your build statement to put your wifi firmware and clm blob into external flash for 4343W, 43364, 43438 platforms. Your updated build statement should look like snip.scan-BCM94343WWCD1 download download_apps run. Please check the Release Notes: WICED Studio 6.0.0 for further information on this.