- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
I use a SILIOS sensor in my project to measure the intensity of light in a room. The sensor is associated with a CYPRESS CY7C68014A integrated microcontroller. I want to transfer the measurement data from the microcontroller CY7C68014A to a Nucleo STM32 board.
Do you have any idea to do it ?
Thank you.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
FX2LP has a USB 2.0 device interface, I2C interface, UART interface and a 16-bit parallel GPIF interface. You can use either of these interfaces to connect with the Nucleo STM32 board based on what interfaces does the Nucleo provide.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
FX2LP has a USB 2.0 device interface, I2C interface, UART interface and a 16-bit parallel GPIF interface. You can use either of these interfaces to connect with the Nucleo STM32 board based on what interfaces does the Nucleo provide.