- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I tried programming CY8CMBR3110 with miniprog 3, with PSOC programmer and EZclick 2.0 and the device is not found.. I tried with windows 10 and in windows 7 (in a virtual machine on Windows 10 how host)
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
MBR3 devices are configurable devices and are not programmable devices.
You could configure MBR3 device in EzClick software preferably or through I2C from any host/Bridge control panel or third party programmer.
Please refer to section 5.2 of http://www.cypress.com/file/46366/download
In case you need to program the hex file generated from EzClick using third party programmer, then please refer to http://www.cypress.com/file/133376/download and Cypress PSoC Programmer
Regards,
Shanmathi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
MBR3 devices are configurable devices and are not programmable devices.
You could configure MBR3 device in EzClick software preferably or through I2C from any host/Bridge control panel or third party programmer.
Please refer to section 5.2 of http://www.cypress.com/file/46366/download
In case you need to program the hex file generated from EzClick using third party programmer, then please refer to http://www.cypress.com/file/133376/download and Cypress PSoC Programmer
Regards,
Shanmathi