- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I recognize that it is normal that the input voltage to the RESET# pin is High when FX3 is operating.
However, due to other circuits, the input voltage may fluctuate between 1.5V and 1.9V when FX3 is operating at the customer's board now.
Is there any problems in this case?
Solved! Go to Solution.
- Tags:
- cyusb3014-bzxi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please refer to Table 8 (DC Specifications) in FX3 Datasheet. If your VIO1 is 3.3V, then Vioh ranges fromm 0.625 * VIO1 to VIO1 + 0.3, that is 2V to 3.6V
So the fluctuations in your board might cause problem. We recommend you to rework your board and provide required isolation.
Regards,
- Madhu Sudhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It depends on the VIOH (min) value of RESET pin @ 3.3V (I believe your CVDDQ is at 3.3V). Unfortunately this information is not available in the FX3 datasheet.
Cy tech support, please help.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please refer to Table 8 (DC Specifications) in FX3 Datasheet. If your VIO1 is 3.3V, then Vioh ranges fromm 0.625 * VIO1 to VIO1 + 0.3, that is 2V to 3.6V
So the fluctuations in your board might cause problem. We recommend you to rework your board and provide required isolation.
Regards,
- Madhu Sudhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Madhu,
CVDDQ is powering RESET IO, not VIO1. The IO levels for RESET pin may be different from GPIOs. Please clarify.