- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
is there an example schematic and FW on how to implement USB OTG on an S6E1C3-family MCU? This for use with a micro USB with ID pin.
Which is the default state device/host/disabled (nothing connected)?
How will the MCU detect the device vs host connection? ID, VBUS, D+ D-.
How will the power supply and current limiter when in host-mode function? And how will it be turned of in device-mode?
What de-inits and inits does the USB stack need to do on detection of device or host?
I know this is a lot at once, but I good example for FM0+, FM3, FM4 or perhaps PSOC will get me on the way.
Thanks!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please make use of Cypress USB Wizard for configuration and code generation across FM devices. http://www.cypress.com/solutions/fm-connect-usb
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please make use of Cypress USB Wizard for configuration and code generation across FM devices. http://www.cypress.com/solutions/fm-connect-usb