- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I think that each SLEEP# and POWER# outputs are connected internally 5.6kohm resistors for pull-up and pull-down.
Is it correct?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Inoue-san,
- The pull-up/down resistors that you have mentioned refer to the internal pull-up/down.
- When a GPIO is to be used as an output pin, there is no need for an external pull-up/down to be connected.
- When a GPIO is configured as an input pin, there should be a pull-up/pull-down present on the pin so that the pin is in a known state nd not left floating.
Best regards,
Srinath S
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Inoue-san,
- The pull-up/down resistors that you have mentioned refer to the internal pull-up/down.
- When a GPIO is to be used as an output pin, there is no need for an external pull-up/down to be connected.
- When a GPIO is configured as an input pin, there should be a pull-up/pull-down present on the pin so that the pin is in a known state nd not left floating.
Best regards,
Srinath S
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Srinath-san,
Thank you for your answer.
I understood it.
Best Regards,
Inoue