Anonymous
Not applicable
Sep 18, 2017
01:19 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 18, 2017
01:19 AM
Dear All,
Normally, EzI2C starts with Comm+Device Addr and then base address follows.
I would like to cancel base address byte. I don't want to use it. I don't want it to be sent and received.
Is there any way to extract this byte in communication array.
Many thanks for any help.
Regards.
Solved! Go to Solution.
- Tags:
- ezi2c base address
1 Solution
Sep 18, 2017
03:43 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 18, 2017
03:43 AM
Use a simple I2C communication component. Then you are free to use your own protocol or none.
Bob
1 Reply
Sep 18, 2017
03:43 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 18, 2017
03:43 AM
Use a simple I2C communication component. Then you are free to use your own protocol or none.
Bob