4 Replies Latest reply on Jul 22, 2015 12:32 PM by gdepaula

    Why aren't my GPIO's changing with my code?

    zosh_2203481

      Hi all,

       

      I'm using Broadcom's sample code almost exactly now, and before I was trying to run a linear resonant actuator (through a transistor) with my TAG dev board, now I'm just using a multimeter, and no matter what I do, I can't change the configuration of the pins and pull them high/low. I have gpio_configurePin(port,pin,GPIO_OUTPUT_ENABLE,GPIO_PIN_OUTPUT_HIGH/LOW) and gpio_setPinOutput(port,pin,GPIO_OUTPUT_HIGH/LOW), and nothing. Any ideas?