- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
psoc creator 4.1, psoc 5LP board, win10
I found usb driver is recognized correctly in my PC(win10) after installing psoc driver(cyusb3.sys, cyusb3.inf).
and i tried "USBFS_Bulk_Wraparound example" with psoc creator.
I couldn't run example software because the driver staus was changed to "unknown USB device"
just after execute "USBFS_Start(USBFS_DEVICE, USBFS_5V_OPERATION)" funtion in main.c.
How can i solve this problem?
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello ,
Can you have a look at the KBA:
Drivers for EZ-USB® FX1™, FX2LP™ , and FX3 - KBA94413
Try to point to this driver.
------------------------------------------------UPDATE--------------------------------------------------
Please download Fx3 SDK from given Path and install.
install and bind driver from below path after SDK installation.
C:\Program Files (x86)\Cypress\EZ-USB FX3 SDK\1.3\drive
------------------------------------------------END----------------------------------------------------------
Thanks,
Hima
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello ,
Can you have a look at the KBA:
Drivers for EZ-USB® FX1™, FX2LP™ , and FX3 - KBA94413
Try to point to this driver.
------------------------------------------------UPDATE--------------------------------------------------
Please download Fx3 SDK from given Path and install.
install and bind driver from below path after SDK installation.
C:\Program Files (x86)\Cypress\EZ-USB FX3 SDK\1.3\drive
------------------------------------------------END----------------------------------------------------------
Thanks,
Hima