- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am using CYBLE222014 chip and MiniProg3. I want to flash the chip using MiniProg3 SWD(5pin), but i cannot toggle power of the chip. I am getting the error below:
WARNING! | Power was not toggled! Please unplug and replug the programmer into the USB port or Toggle the power again
i tried to replug but did not work.
I am getting same error when using EzBLE Module. If i connect UART0 cables, it cannot toggle power. If i remove the UART0 cables, it can toggle power.
Edit: More Information
I supply power the chip via battery,
My Programmer configuration is:
Programming mode: reset
Connector: 5p
Protocol: SWD
Voltage: 3.3V
Status Voltage changes between: 3480 - 3500mV
On right corner of the window, status shows connected and powered. When i try to flash i get new error message (i cannot still toggle power via button)
| FAILED! PSoC device is not acquired! Check connection of the chip to the programmer
|
Please, check the following items:
| - the connection between the programmer and the PSoC;
| - the correct programming protocol is selected;
| - the correct connector option is selected.
EDIT 2: I think I started to understand the programmer. I am using external power supply so i cannot toggle the power using programmer. I need to use it in Reset mode.
But still programmer can not acquire the device.
EDIT 3: Chip is working. I can scan the chip via Smart Phone.
Thanks in advance,
Mert
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you try setting the Miniprog voltage from 3.3V to "External" ?
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, I tried, nothing changed.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Problem is fixed.
Our costum board was wrong.