- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI,
I just installed the CY8CKIT-002 for the purpose of programming a CY8C24123. I don't see the CY8C2 device family in drop down option list. Is there a separate download to add this family? If not, how do I do it?
Thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Disconnect the MiniProg3. Select ISSP in the Programmer Characteristics group. Now the Device Family and Device Selectors would be enabled. Select 24x23 in the Device Family selector and then Cy*C24123 in the Device selector.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Disconnect the MiniProg3. Select ISSP in the Programmer Characteristics group. Now the Device Family and Device Selectors would be enabled. Select 24x23 in the Device Family selector and then Cy*C24123 in the Device selector.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks samp. The required steps were less than obvious.