- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I want to develop control unit for burner, kindly advise me, which board kit is near to match my requirements .!
I want to control burner flame with pressure and temperature sensors and three units are attached with burner working.
1: System start up with ( control : Monitor pressure and Temp by sensors )
2: Glow Plug 12v 17A (control : switch on/off with timer + Temp sensor )
3: Blower fan 12V 11A, ( Control : switch on/off + PWM variable speed + temp sensor
4: Fuel Pump 12V, 4A, PWM ( Control : Switch on/off + variable speed + temp sensor
Burner system will start up when Pressure and Temp will reached at desired level.
1st glow plug will on for produce flame , 2nd blower will on with low flow, 3rd fuel pump will on for produce continuous flame,
1: MCU 32Bit Cortex M4 200Mhz
2: Flash 2mb + Accelerator
3: Ram 512
4: 2USB + 2 CAN
5: Ethernet IEEE 1588
6: ADC 8
7: Power on/off 6 Mofsets
8: Temperature Sensor 6
9: Pressure Sensor 6
10: Jtag header
11: TFT controller + LCD
10: I/O 20
11: Multi Function Alarms 4 +RTC
12: PWM 8
Awaiting your helpful reply.
Regards
Sami
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Spamming the forum with the same question all over is really a bad habit!
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Presently ,PSoC has no Ethernet IEEE 1588 support