Anonymous
Not applicable
Jul 06, 2011
08:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 06, 2011
08:37 PM
I hope update the cy_clock module that can be enabled with input connection.
Solved! Go to Solution.
Labels
- Labels:
-
PSoC 3
1 Solution
Anonymous
Not applicable
Jul 11, 2011
03:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 11, 2011
03:56 AM
Dear yliu & U2 In fact, I would like to have a Synchronous detection clock,input to the Mixer module,and phase can be adjusted. [For example, input 48MHz clock, output 1MHz clock , 7.5 degrees / bit phase can be adjusted ,control signal(Enable) from the DUB module.] Thanks Best Regareds Sui
3 Replies
Jul 07, 2011
02:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 07, 2011
02:48 AM
Hi Sui,
Would you also let us know the embarrassment/disadvantage of the software enable?
Regards,
Roy
Roy Liu
Anonymous
Not applicable
Jul 09, 2011
09:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 09, 2011
09:22 AM
Do you intend to say that, we need to provide an enable terminal for clock component. Could you throw some light on what you intended to ask?
Anonymous
Not applicable
Jul 11, 2011
03:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 11, 2011
03:56 AM
Dear yliu & U2 In fact, I would like to have a Synchronous detection clock,input to the Mixer module,and phase can be adjusted. [For example, input 48MHz clock, output 1MHz clock , 7.5 degrees / bit phase can be adjusted ,control signal(Enable) from the DUB module.] Thanks Best Regareds Sui