Where is basic example code for FM4-176L-S6E2CC-ETH Kit?

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
VlYe_281166
Level 4
Level 4
25 replies posted 10 replies posted 10 questions asked

In contrast to PSoC, I see no support at all for FM4.

   

The question is: Where are examples for FM4 in the form of the IAR, MDK , etc. projects????

   

At least, where is the basic code(.c and .hex) flashed in FM4-176L-S6E2CC-ETH at the factory?

0 Likes
1 Solution
4 Replies
Anonymous
Not applicable

Please update the link to the S6E2CC Starter Kit program/firmware.  (Used in the SK-FM4-176L-S6E2CC.)

   

Performing an environmental test and socketting the board, and want to program multiple ICs with this program.

   

Thanks!

0 Likes
Anonymous
Not applicable

Dear sir,

   

            I am using stack provided by the cypress for Ethernet. I found that reset signal is required for MAC module to run it in FLASH mode. Can any one suggest, how to reset MAC in software .we are using  controller S6E2CCAL0.Looking forward for your valuable reply.

0 Likes