- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In contrast to PSoC, I see no support at all for FM4.
The question is: Where are examples for FM4 in the form of the IAR, MDK , etc. projects????
At least, where is the basic code(.c and .hex) flashed in FM4-176L-S6E2CC-ETH at the factory?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
PDL can be referred to
http://www.cypress.com/documentation/software-and-drivers/peripheral-driver-library-pdl
Also the below page has the example/template code:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
PDL can be referred to
http://www.cypress.com/documentation/software-and-drivers/peripheral-driver-library-pdl
Also the below page has the example/template code:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please update the link to the S6E2CC Starter Kit program/firmware. (Used in the SK-FM4-176L-S6E2CC.)
Performing an environmental test and socketting the board, and want to program multiple ICs with this program.
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear sir,
I am using stack provided by the cypress for Ethernet. I found that reset signal is required for MAC module to run it in FLASH mode. Can any one suggest, how to reset MAC in software .we are using controller S6E2CCAL0.Looking forward for your valuable reply.