- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i am using capsense on PSoC3 CY8C3245LTI-144 [Silicon ID: 0x1E090069].
while building it is not showing any warning, but at the time of programming it is showing one of the following errors.
errors are shown in attached file.
my .cydwr page and build settings are also shown.
what kind of probiem it should be?
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Nilesh,
As per the first error message it looks like the device selected for building the project is not same as that on the kit. Please check if the device selected for building the project is same as that on the kit.
Regards, Aniruddha
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi NileshTekale,
1) Which version of PSoC3 are you using? You can find that by reading the name on the chip, which might read like CY8C3245LTI-144ES1 or CY8C3245LTI-144ES3. It is important that the device selected matches with the actual device being programmed (Including the ES1, ES2). If there is a missmatch, then choose the appropriate device from Project > Device Selector
2) Are you powering the device externally or using Miniprog3 to power the device while programming?
3) Did you try programming the device using PSoC Programmer?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yes the device is same.
i have connected
XRES to P1[2] and also
VTARG pin of Miniprog3 to VDDIO1 of PSoC.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
on ic es1 or es3 is not mentioned.
it has
CY8C3245LTI-144 1125
A 04 PHI.
2) no external power supply used it is given by miniprogrammer3 and it is set on 5v.
3) yes i tried psoc programmer and same error appears.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi NileshTekale,
Is this problem solved? Can you share how if you remember?
I guess the most possible reason if hardware connection issue, see the other thread in below link:
http://www.cypress.com/?app=forum&id=2232&rID=70330
Thank you,
Roy
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@yliu, do you think NileshTekale is still following this thread
7 months later, just a thought........
Regards, Dana.