- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I want to know a scale range of EMG signal & how about a gain that i'll programm into the instrumentation amplifier
regards, thanks for your answer
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You will have to use external IA to accomplish CMR and signal
path G.
http://www.cypress.com/?app=forum&id=2492&rID=82151 IA CMR Analysis
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You will have to use external IA to accomplish CMR and signal
path G.
http://www.cypress.com/?app=forum&id=2492&rID=82151 IA CMR Analysis
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
so i want to thank you about what do you sent , but i want to have the answer of my question
regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1) The TI white paper I sent you describes roughly the magnitude and
frequency of the signal at the sensor site.
2) You determine what you are going to do with that signal. So you have set
specs for the magnitude of the signal you want to digitize, what is that value ?
3) Then Gia = Your desired signal / Sensor signal
4) The datasheet for the sensor will tell you what levels to expect.
5) You have also set the resolution of the digitized results that you want, what is that ?
6) You have set the desired rejection to common mode signals, like 50 / 60 Hz, what
is that value ?
Regards, Dana.