- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I had read the document AN73503 which is about USB Bootloader. And also download the project, but after the component update, the project has servals errors.
Solved! Go to Solution.
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bootloader and Bootloadable
Of course, those must use same device.
You have to ensure that.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Maybe you are using KitProg, PSoC5 version
Can you find PSoC3 version?
I would be search it and show you later.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bootloader and Bootloadable
Of course, those must use same device.
You have to ensure that.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I compiled (after updating the project) with Creator 3.0 without any errors.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank guys help. I haven't a Mini Prog3. My board is CY8CKIT-030 PSoc 3 Development kit. Hope someone can give the mini prog3. And I can update my software to Creator 3.0, Let me try it
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You do not need a miniprog 3 to program a -030Kit.
There are two (2) USB connectors on the board, one is for programming and debugging, the other is connected directly to the PSoC3. I suggest you to have a look into the schematics.
When using a bootloader you will have to use the second USB-port to update the chip with the new bootloadable.
Sounds a bit complicated .
There is something else I remember (Hopefully some other helper will jump in here) I have in mind that projects using the second USB as bootloader should run at 3.3V but I may be totally wrong with that.
Bob