Aug 10, 2017
08:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 10, 2017
08:05 AM
Hi,
I want to make use of entire Port1 of CY8KIT-059 (PSoc5 stick). Unfortunately, Pins 1.0, 1.1 and 1.3 are taken by JTAG and not assignable (screenshot attached). Is there any way to reclaim those pins? Are they become available if using Miniprog3?
Solved! Go to Solution.
Labels
- Labels:
-
PSoC 5LP
1 Solution
Aug 11, 2017
01:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 11, 2017
01:09 AM
Just setting the debug mode to GPIO (in System view) will free all pins to normal use. Setting those to SWD will keep the kitprog debugging active but will need two pins.
Bob
3 Replies
Aug 10, 2017
08:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 10, 2017
08:18 AM
screenshot
Aug 11, 2017
01:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 11, 2017
01:09 AM
Just setting the debug mode to GPIO (in System view) will free all pins to normal use. Setting those to SWD will keep the kitprog debugging active but will need two pins.
Bob
Aug 12, 2017
09:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 12, 2017
09:34 AM
Thank you Bob. That was easy.