Anonymous
Not applicable
Mar 03, 2015
08:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 03, 2015
08:37 PM
I'm using bcm20732s with wiced smart 1.1.0, I have found all of app source code in 1.1.0, but I did NOT found any piece of code to tell me how to use security in 1.1.0.
In 2.x, it's easy to enable security, just comment out PASSKEY in hello sensor application sample.
I just want to know that how to initial security section in 1.1.0 if I want to use pass key.
Solved! Go to Solution.
1 Solution
Mar 04, 2015
03:40 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 04, 2015
03:40 AM
2 Replies
Mar 04, 2015
01:46 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 04, 2015
01:46 AM
i think the below thread may provide some insights into your problem.
Mar 04, 2015
03:40 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 04, 2015
03:40 AM
I'm pretty sure that PASSKEY pairing wasn't supported until SDK 2.0