- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Whenever I program the FX3 with the Control Center, I always get "Programming Failed" even though the DVK will enumerate as the new device. Is this just a bug in the conrol center or is the FX3 not programming correctly?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Are you using the release version of Superspeed SuiteUSB? This issue should have been fixed in that. Please check and let me know.
Regards,
Anand
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, I am using the released version of the Superspeed SDK. The version of the driver is:
The version of the USB Control Center is:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have the same problem, and my version of Cyconsole 1.0.0.1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I confirmed with Cypress FAE that this is still a bug.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
no problem when using the usb2.0, programmer failed only when you are using usb3.0.
just turning on cycontrol again, can write is possible. but annoyance every time.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Installed the latest versions, confirmed the problem with USB3.0, USB2.0 is OK.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Same problem here.
It only happens with some USB controllers.
On my main Win7 x64 development machine these controllers report that programming failed.
Renesas uPD720200, uPD720201, Etron EJ168, TI7340, ASmedia ASM1042
But it doesn't happen withFresco Logic FL1009 or VLI VL800. It succeeds on these.
Even though it reports that it failed on the Renesas controllers, it does actually work (the downloaded code is up and running afterwards).
On a different machine, but still Win7 x64, it does report success with a uPD720200. but fails on uPD720201.
The same hardware on Win8 release preview gives different results again.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a same problem. My computer uses on board Etron EJ168 USB3.0 controller. How can I fixed the programming failed problem?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Same problem here. Using my new laptop with Intel USB 3.0, programming the RAM fails. 2.0 works fine. Using a desktop with ASMedia controller, and RAM programs correctly.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Few more issues are solved in the latest SDK. Please try with that one.