- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I've got a cy3268 and I've programmed It correctly using the ice-cube. My problem is that when I try to debug using the ice-cube I get the message-window that says that the designer cannot connect to the ice. The message is exactly the one in the jpg that I have attached. I get the message after doing Debug->Connect from the menu of PSoCDesigner. The ice-cube is connected to the cy3268 in the same way It was when I downloaded the program in the board and in that occasion everything worked fine. I'm using PSoCDesigner 5.1 which I've recently downloaded.
Thanks for the help and have a nice day.
Trinca Claudio
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Claudio,
This forum is for PSoC5 devices, that are programmed using PSoC Creator software. Your question will be appropriate for another forum like (maybe) PSoC1 > Device Programming.
Sorry for not being any more helpful!
Raj