- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Anyone know if it's possible to rout the output of an external Current sense amplifier to the the feedback of the hysteric controller 0 through pin FN_0_1 in stead of pin FN_0_0? I have inadvertently designed my pcb with the output of my CSA going to pin FN_0_1 instead of FN_0_0. I am using the CY8CLED01D01-56LTXI. Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I would suggest you post a tech case at www.cypress.com, main menu on
homepage, "Support", "Technical Support", "Create a Case"
I looked at part using Designer 5.3, I could not find any obvious route. But
my experience in Power PSOC severly limited.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately, HYSTCTL0 can take the feedback input only from CSA0 or FN0_0. It is not possible to route FN0_1 to HYSTCTL0 feedback input.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the help! I guess ill have to physically rout it to FN_0_0 untill i have a new board built.