- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello everyone
one problem :what can lead fx3 (usb 3014) to warm reset(cpu counter reset).Please tell me all of the possible reasons (hard ware or software)
when my device connect with USB3.0 port ,it is likely warm reset always.
thanks
best regard!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ayi,
if you are using your own custom board, then it is possible that your voltage supplies of USB3 RX/TX are not good enough. If it resets at the function call CyU3PUsbConnect(true,true); then this is the case. Then refer to application note of hardware reference guide.
regards,
lumpi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI Lumpi6
Thanks for your replay.I use my custom board. Maybe the voltage supplies of USB3 RX/TX are not good enough.
But can you tell me hao to check that ? And what is the right voltage supplies of USB3 RX/TX wave ?
thanks
Best regard!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
For power supplies(This applies for all power domains, VDD,AVDD...), make sure you are using regulator with right voltage and current specification, proper decoupling and bulk capacitors, Bulk and decaps should be placed close to Silicon(Decap near to the pin), use wider tracks for power supplies.
Please look into our DVK design files(layout and schematic) http://www.cypress.com/?rID=58321 and design recommendations mentioned in http://www.cypress.com/?rID=53203.
-PRJI
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI PRJI
Does U3TX_VDDQ voltage unstable can lead the problem? U3TX_VDDQ min 1.0 max 1.35. The document said it is 1.15-1.25
best regard
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ayi
Please refer to AN70707: http://www.cypress.com/?rID=53203
Section "Inrush Current Consideration and Power Supply Design" of the above Application note will answer your question.
Thanks
Nikhil
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
You should change your U3TX_VDDQ supply to meet 1.15-1.25V requirement.
-PRJI