Anonymous
Not applicable
May 24, 2010
11:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 24, 2010
11:37 AM
Hi to everyone and thanks in advance for your help!
I would like to directly connect two FPGA dev board, both with Cypress FX2LP USB chip, to communicate data via USB. Is that possible in some way? thanks!!
2 Replies
Anonymous
Not applicable
May 30, 2010
09:04 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 30, 2010
09:04 PM
Hello,
This is possible.Please go through our appnote on FX2LP-FPGA interface available for download here. You can use a chip select line to distinguish between the FPGAs.
Hridya
Anonymous
Not applicable
Mar 13, 2014
01:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 13, 2014
01:09 AM
Hi
This is for benefit of new visitors.Its not possible to establish communication between 2 FX2LP chips via USB. In this case, you will need one of the chips to act as USB host ( master) but FX2LP has only device capability ( USB slave )
Regards
Mudabir Kabir