- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All
I am extremely new to Cypress and using the CY8CKIT-042-BLE PSoC 4/PRoC Pioneer Kit. I am looking to store some data to the onboard Flash on the PSoC 4 and then access it. The version I have has 128K of Flash. I did look around for some specific tutorials or even some sample code, but could not find anything.
I also came across somewhere which says to use the Emulated EEPROM component to write to Flash. I don't know if that is the correct way to do it or not, but I do not see the Emulated EEPROM Component Under the 'System' in the PSoC Creator 3.3 !!
Any help will be much appreciated. Thanks a lot in advance.
Aviraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bob, I tried running the example project on writing to SFlash but for some reason the program goes into an infinite loop. In debug mode, the program stops here: CY_ISR(IntDefaultHandler). Is there a reason for this ? I did not change the code.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, did you get this resolved? i'm having exactly the same problem
regards,
Damian