- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I used CY8C24533,CY8C27643 and CY8C29666, but only CY8C29666 save data to the E2PROM, if the address is wrong, the program area will be destroyed, such as digital controls are not displayed, the program can not run. Many similar situations happen, I need to address one by one to try, such as
save six bytes of data should be: E2PROM_E2Read (0, SAVE, 6);
but I need wirte :
E2PROM_E2Read (1, & SAVE [0], 1);
E2PROM_E2Read (7, & SAVE [1], 1);
E2PROM_E2Read (12, & SAVE [2], 1);
E2PROM_E2Read (18, & SAVE [3], 1);
E2PROM_E2Read (28, & SAVE [4], 1);
E2PROM_E2Read (58, & SAVE [5], 1);
who can help me???
- Labels:
-
PSoC 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When you start PSOC Designer there is a project using EEPROM you
can try out and/or use -
On start page "Launch Example Browser", and you will see E2PROM example in the
list.
This might help as well - http://www.cypress.com/?docID=34929
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you post your complete program here so that we all can have a look at the internal settings you provided.
To do so use Designer's function "Archive Project" and upload the resulting .zip file here using internet explorer (CHROME does NOT work)
Bob