5 Replies Latest reply on Jan 3, 2010 10:15 PM by userc_45102

Variables for the Bridge Control Panel

userc_45103 Jan 3, 2010 10:15 PM

        I have just started using the CY3271 First Touch Starter Kit, and found that it works very well.

I want to make an application for proximity sensing and need to see the raw data from the sensor.

The Bridge Control Panel shows both some digital and analog values, but how can I find the adress for my variables in the code?

Or: how can I define my variables so I can explore them via the Bridge Control Panel?

Thanks in advance

Poul

1. Re: Variables for the Bridge Control Panel

userc_45103 Nov 24, 2009 2:42 PM (in response to userc_45103)

Solved!
Like Show 0 Likes(0)

Actions
2. Re: Variables for the Bridge Control Panel

userc_45102 Dec 6, 2009 11:22 PM (in response to userc_45103)

How?
Like Show 0 Likes(0)

Actions
3. Re: Variables for the Bridge Control Panel

mganeshr_41 Dec 7, 2009 1:05 AM (in response to userc_45103)

        Glen,

Check out the Help >> Help Contents menu in the Bridge Control panel. This has details about setting up variables and how to write commands to read the variables under the following sections.

Communication >> Command Lines
Data Processing >> Variable Definition
Like Show 0 Likes(0)

Actions
4. Re: Variables for the Bridge Control Panel

userc_45103 Dec 7, 2009 12:56 PM (in response to userc_45103)

        Better yet:

Read the

EzI2C Slave Data Sheet

which explains the functionality in a good way.

Best regards
Poul
Like Show 0 Likes(0)

Actions
5. Re: Variables for the Bridge Control Panel

userc_45102 Jan 3, 2010 10:15 PM (in response to userc_45103)

        Cheers to both,
I couldn't work out what UM to use.

The Ez Datasheet explained it much better.
Like Show 0 Likes(0)

Actions

Go to original post