Anonymous
Not applicable
Jan 22, 2010
07:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 22, 2010
07:01 AM
I want to use I/O port as a switch to control outside resister network, I find the resister between pin with GND is not 0 ohm when the I/O pin is set a open drain low and the Pin output is low.
if I want to get a low resister near zero Ohm between pin with GND, How do I want to do?
Best regards,
David
if I want to get a low resister near zero Ohm between pin with GND, How do I want to do?
Best regards,
David
2 Replies
Jan 22, 2010
09:46 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 22, 2010
09:46 AM
Anonymous
Not applicable
Jan 23, 2010
12:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 23, 2010
12:54 AM
Dear Ganesh,
Thank you very much!
Best Regards,
David
Thank you very much!
Best Regards,
David