Anonymous
Not applicable
Oct 03, 2008
07:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 03, 2008
07:14 AM
We have a test set using primer.exe to prime CY7C683000 devices.
The host PC crashed and was re-installed with XP (including a reformat).
Primer.exe runs, but no longer detects new devices.
I have tried installing the drivers that came on the AT2LP CD, but it makes no difference. There is no installer as such on this CD.
If I plug the unit in without primer.exe, it comes up with Found New Hardware AT2LP RC42, but won't recognise any of the available .inf files.
If I then plug the unit into a machine with a working installation, the device primes OK. I need to get the test machine working again.
Anyone got any ideas?
Thanks
Malcolm
The host PC crashed and was re-installed with XP (including a reformat).
Primer.exe runs, but no longer detects new devices.
I have tried installing the drivers that came on the AT2LP CD, but it makes no difference. There is no installer as such on this CD.
If I plug the unit in without primer.exe, it comes up with Found New Hardware AT2LP RC42, but won't recognise any of the available .inf files.
If I then plug the unit into a machine with a working installation, the device primes OK. I need to get the test machine working again.
Anyone got any ideas?
Thanks
Malcolm
0 Replies