Anonymous
Not applicable
Mar 22, 2010
12:41 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 22, 2010
12:41 PM
Can CY7C64215 be programmed in-situ using MiniProg3 that is included in the PSoC3/5 Dev Kit? Since EnCore III is based on the same MCU as PSoC1, I am guessing it is possible in theory.
I understand that I cannot use it to debug it (like it cannot any PSoC 1 chips) but can anyone confirm or deny it can program the part using ISSP before I go down designing around it?
Thanks.
Hiroo
I understand that I cannot use it to debug it (like it cannot any PSoC 1 chips) but can anyone confirm or deny it can program the part using ISSP before I go down designing around it?
Thanks.
Hiroo
Labels
2 Replies
Mar 23, 2010
01:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 23, 2010
01:31 AM
Hi Hiroo,
Yes. MiniProg3 can be used to program the 64215 device.
Yes. MiniProg3 can be used to program the 64215 device.
Anonymous
Not applicable
Mar 24, 2010
11:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 24, 2010
11:06 AM
Excellent! Thanks for confirming it.
Hiroo
Hiroo