Anonymous
Not applicable
Jun 30, 2010
11:10 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 30, 2010
11:10 PM
I am getting the following error when I try to program my psoc5 first touch board.
dbg.M0023: There was an error while programming the device: (PSoC Creator received error (100 - ))
I am able to see the debug target withing Psoc Creator as well as 3.11 Programmer.
I get the same error if I use the programmer directly rather than running through Creator.
Labels
- Labels:
-
PSoC 5LP
1 Reply
Anonymous
Not applicable
Jul 01, 2010
10:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 01, 2010
10:01 PM
The problem has been figured out. Apparently I have some problem USB ports on my main box.
When I plugged into a powered USB hub, I was able to successfully program the device.