How to connect an output signal of Page1 of schematic to an input of same module in Page2

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable
        Hi. I am in trouble. I draft my circuit diagram dividing two pages on PSoC Creator. I want to connect an output of schematic page1 to an input of page2. Please some one show me how to connect two signal of page1 and page2. Thanks your help.   
0 Likes
2 Replies
TeHe_281121
Level 3
Level 3

Hi marusan,

   

You connect signals between sheets using the sheet connector.

   

Press the 'S" key and a sheet connector will show. Wire it to the signal you want to connect to and give the signal a name.

   

In the connecting sheet do the same and give the signal the same name.

0 Likes
Anonymous
Not applicable
        HI, Thanks your good advice! After connecting the sheet connector and same signal input or output by wire tool, I could change signal name of the sheet connentor. Then, I could buid successfully.   
0 Likes