I am a newbie with Cypress and I am trying to use the csdauto module in a CY820436A with a 3.3v supply at 24Mhz. (I also tried 12Mhz but that didn't help with my issue).
The issue: In assembly I call the csdauto_Start api and I can see the signal on my selected sensor pad. But the program does not continue past this point. To verify that it hangs, I programmed it to set a port pin high right after calling csdauto_Start and the pin never goes high. (I have proven that I can set this pin high so that is ruled out as the issue).
My Settings: In the chip window> csdauto properties window I left all properties at their default settings. Using the wizard I selected P01 as the modulator cap pin and I connected 1 switch to my sensor pin. Only 1 switch is activated in the wizard. I selected 0 for the slider option. Any ideas on why the program could hang during the csdauto_Start api?
