Hello,
I got the PSoC FirstTouch Starter Kit with cyfi Low-Power RF (CY3271) and have a problem to run the RC Bridge Wireless Hub firmware. I followed the description of the cy3271 Kit Guide manual.
My Problem is that I can't change the IRQ_Pin to Port_2_6 of the RF-CYFISNP Module. It is also not possible to change the nSS_Pin to Port_2_7. I get only the following choices:
IRQ_Pin: None, Port_2_1, Port_2_2, Port_2_4
nSS_Pin: None, Port_2_1, Port_2_2, Port_2_4
I have already taken note of this page, and made the changes:
http://www.cypress.com/?rID=39430
I use the PSoC Designer 5.0
does anyone know how to fix the problem?
Best regards, Nico
