- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
this post is the continuation of post "Ice cube recognition problem".
I have the cy3268 on which there is the cip whith the following marking:
CY8CLED04DOCD
1-56LTXI 0931
B 04 CHI
CYP 626613
The programming of the board with the ICE CUBE works fine, the problem is when I trie to do the debug. At this moment when I select "Debug->Connect" from the Designer I receive the message "Attached pod (00bf0022) is not compatible with the selected PSoC".
Looking around on the cypress web site I've found a similar post that goes like this:
Error Message: "Attached pod (000e1022) is not compatible with the selected PSoC" Last Updated: 11/30/2010 | ||
Question: I get an error message " Attached pod (000e1022) is not compatible with the selected PSoC" while using the new CY8C27002-24PVXI OCD part while debugging with PSoC Designer. This is the latest revision OCD part (B 05 datecode 1001). | ||
|
I am using PSD5.1 but is my problem anyway similar to this one?
Thank you very much and have a nice day.
Trinca Claudio
- Labels:
-
PSoC 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Looking at the symptoms you have described in the other post, I dont think your problem is pod incompatability. I have mentioned some points to check in the other thread. Please check them and let me know if any of them solves your problem.
Best Regards,
Ganesh