- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Good Morning!
I am doing on Powerline communication using CYCPLC20- 28PVXI. In coding, when i use the function PLT_Start(), its equivalent asm says this function switches the modem to receiver. I want to use modem to transmitt. How can i make the PLT_Start function to start the transmitter?
- Labels:
-
PSoC 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I will try to get some PLC experts to provide you a response soon.
Best Regards,
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Mouni,
PLT_Start() configures the PLT in receiver mode by default.
When you are using the PLT module in FSK Modem mode you can switch to the transmitter mode by using PLT_SwitchToTransmitter() and back to receiver mode with PLT_SwitchToReceiver(). To transmit data in FSK Modem mode use PLT_SendData().
When the PLT module is used with the network protocol Use PLT_SendMsg() to prepare the message to be transmitted followed by PLT_Poll() to send the message.
Regards,
Aditya