Jul 13, 2011
09:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 13, 2011
09:55 PM
As I know PSoC3 just use 2pins, P1[0] and P1[1] with SWD.
So, I disconnect P1[3] with debugger and disable SWV option.
but It works perfectly with compile and debug.
I'm sure the SWV(P1[3]) does not working now.
so, i was put a rx_pin at P1[3] and try to compile.
but PSoC Creater shows me below message.
Cannot place "Rx_1(0)" at "[Chip=0][IOP=(1)][IoId=(3)]" because the location is reserved by "SWD debug".
It is connect in hardware?
or just Software problem?
if anyone know, please reply.
Thank you.
Labels
- Labels:
-
PSoC 3
1 Reply
Anonymous
Not applicable
Jul 15, 2011
12:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 15, 2011
12:50 AM
The Pin P1[3] was reserved for specific purpose in older revisions of PSoC3 silicon. Hence creator was giving this warning. A newer version of Creator will be available soon which will have fix for the issue you have mentioned.