Anonymous
Not applicable
Oct 13, 2011
01:56 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 13, 2011
01:56 PM
Hi,
What is the difference between defining endpoints in USB setup call back funrtion vs the Thread_Entry (or ApplnInit() ) function? I found both in the sample codes.
Thanks,
Nazila
2 Replies
Anonymous
Not applicable
Oct 14, 2011
02:08 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 14, 2011
02:08 AM
Can you please let me know the firmwares that you're looking at?
Regards,
Anand
Anonymous
Not applicable
Oct 14, 2011
11:52 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 14, 2011
11:52 AM
Endpoint defined in USB callback setup:
- Bulk loop manin out
- Bulk loop man many to one
- Bulk loop auto many to one
Endpoint defined in Thread_Entry or ApplnInit
- Bulk loop manual
- usb spi reg mode
- usb spi dma mode
Endpoint defined in USB Event call back
- Bulk streams
- Bulk src sink
I would appreciate it if you could tell me what is the difference between defining the Endpoints in each of the functions I mentioned above.
Thanks,
Nazila