cy7c68013 eeprom boot loader

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

 Hi 

   

My demo board in cy7c68013A using the i2c EEPROM(24lc128),but the A2 A1 A0  is connect to ground(0 0 0).

   

Is it possible do not need to change the PCB?

   

Thanks

   

Jack

0 Likes
1 Reply
Anonymous
Not applicable

Hi,

   

                      The EZ-USB uses the EEPROM device-address pins A2, A1, and A0 to determine whether to send out one or two bytes of address. Single byte address EEPROMs must be strapped to address 000, while double byte address EEPROMs must be strapped to address 001. So you should change the hardware.

   

Thanks,

   

Prajith

0 Likes