3 Replies Latest reply on Nov 22, 2011 11:34 PM by udayanu_

Alien come on LCD when sent some characters via UART

suei_281901 Aug 18, 2017 4:05 PM

I've compiled the UART_Rx.cywrk example in the CY8CKIT-001 development kit and have been unable to get it working while sending characters over RS232 using Labview. I've send "LCD". It shown double alpla and japan character. Even I use hyperterminal also same. Any ideas what might be causing the problem?? Thanks.

LV.gif 23.5 K

1. Re: Alien come on LCD when sent some characters via UART

userc_39993 Nov 16, 2011 9:56 AM (in response to suei_281901)

Are the baud rates equal?
Like Show 0 Likes(0)

Actions
2. Re: Alien come on LCD when sent some characters via UART

ki.leung Nov 16, 2011 4:47 PM (in response to suei_281901)

Do you have receiver echo to the transmitter?
Like Show 0 Likes(0)

Actions
3. Re: Alien come on LCD when sent some characters via UART

udayanu_ Nov 22, 2011 11:34 PM (in response to suei_281901)

This could possibly be due to Baudrate mismatch as highlighted in the post earlier. Please ensure that the baud set on the labview module matches with the baud set in the PSoC project.
Like Show 0 Likes(0)

Actions

Go to original post