Anonymous
Not applicable
Dec 09, 2011
04:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 09, 2011
04:18 AM
Dear all,
I am using the CY8CKIT-050 and just recently downloaded the Creator 2.0. Because I am using USB functionality I need to configure the XTAL with 24 MHz. Unfortunatly my Board has no Y3 Crystal assembled.
Can somebody please tell me if the board is prepared for the Y3 24 MHz Crystal or not? I tried to follow the PCB lines, but it looks like there are none connected to the pads.. ( If it is not a Multilayer-Board)
Thanks in advance,
best regards,
Thomas
Labels
- Labels:
-
PSoC 5LP
2 Replies
Dec 09, 2011
07:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 09, 2011
07:11 AM
Yes, it is prepared for the crystal. Look at http://www.cypress.com/?app=forum&id=2233&rID=56823 for a detailed documentation.
Anonymous
Not applicable
Dec 11, 2011
04:28 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 11, 2011
04:28 AM
Thanks a lot, I also found the PCB Layout of the board, and on on inner plane there is the connection..