- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
After plugging BCM9WCDPLUS1_2. eval board to my laptop, two usb Serial Ports are automatically detected and installed.
WICED USB JTAG port is not installed as it happens for a WICED-Wifi board.
I am trying to flash smart ip_bridge software on to this BCM9WCDPLUS1_2 eval board and I get error as ..
"**** OpenOCD failed - ensure you have installed the driver from the drivers directory, and that the debugger is not running ****
i assume the JTAG drivers are not installed for this board or that is not detected at all.
Please let me know the steps to go further
Regards
Yasin
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Drivers for the USB to JTAG and serial ports are located at .../tools/drivers directory of the SDK. Uninstall and install the drivers for USB-JTAG device which comes with the Wiced evaluation board. You can refer to quick starter guide QSG for detailed info.
Seyhan