- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
We are currently using "CYPRESS EZ-USB FX3 CYUSB3KIT-001 DEVELOPMENT KIT" for internal development work.
Our requirement is showcasing our USB Compliance Testing capabilities and would like to make use of this Kit for running the same.
In this context, would like to know the procedure for setting up USB compliance tests station using this Kit.
Any example test code that can put the Kit into Host/Device mode and respond to the Compliance test modes would be very useful.
To begin with we are looking at running USB2.0 compliance test suite (Low, Full and High Speed) and would later extend the same for USB3.0 compliance test suite.
Any quick help on this would be very useful.
Thanks and regards .....
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!,
You can load 'cyfxbulklpauto' example project provided in EZ-USB FX3 Software Development Kit | Cypress Semiconductor
The USB PHY state machine will go to the appropriate state during Compliance test.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!,
You can load 'cyfxbulklpauto' example project provided in EZ-USB FX3 Software Development Kit | Cypress Semiconductor
The USB PHY state machine will go to the appropriate state during Compliance test.