- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!
For some reason,
I can't use FPGA in my project where I need to use 68013A to conduct USB data transfer.
I use STM32 instead of the FPGA as the control logic of CY7C68013A.
then , MUST I feed the pin IFCLK in frequency between 5MHz and 30MHz?
Looking forward to an instant reply!
Thank you!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI,
If IFCLK pine will be driven by an external clock, then it can be at any frequency between 5 MHz and 48 MHz. it must be free running at a minimum frequency of 5 MHz. It is clearly mentioned in Technical reference manual in section 9.2.3.
Regards,
Gayathri
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI,
If IFCLK pine will be driven by an external clock, then it can be at any frequency between 5 MHz and 48 MHz. it must be free running at a minimum frequency of 5 MHz. It is clearly mentioned in Technical reference manual in section 9.2.3.
Regards,
Gayathri