Anonymous
Not applicable
Apr 20, 2012
06:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 20, 2012
06:51 PM
Hi,
We're planning to use the FX3 on a new board with the firmware development in parallel with the schematic. The board will need to be taped out prior to the firmware being done and I would like to have the option to boot from the EPROM. Does anyone have a good feel for the 'typical' image size for a design using the GPIF2 interface? I get the feeling from reading some of the messages in this forum that the images are considerably larger than those from the FX2 (8051 based) and would rather err on the side of caution.
Thanks in advance,
Raphael
2 Replies
Apr 21, 2012
07:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 21, 2012
07:21 AM
Hi,
Typical image size would be about 130- 160KB so you will need two 1024K bit eeproms. Two 24LC1025 will be enough.
Sodafarl
Anonymous
Not applicable
Apr 23, 2012
12:29 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 23, 2012
12:29 PM
Excellent, thanks for your reply.
Raphael