Anonymous
Not applicable
Apr 29, 2012
04:56 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 29, 2012
04:56 PM
My Gpif (16 Bit and only SPI) and the Firmware running fine, as long I do not Using Bit 8 an higher.
If there is any Change on these Bits above, (Debugger is running), any thing from "USB RESET" or "UNKWON SETUP" Requests in various ways is happen.
Sometimes the FX3 make a full Reset (so I can Reload it in Control Center). I build 3 Boards, and all do the same, but in different manner.
Any Help ?
Best Regards
Ralf
1 Reply
Anonymous
Not applicable
Apr 30, 2012
01:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 30, 2012
01:12 AM
Have you tried the same in FX3 DVK?
When you say they're unused are you holding them high or low?
Is bit8 the only line causing the issue?
Regards,
Anand