Configuration device ofr fx3

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable
        Hello i have two questions. 1.) I intend to use i2c eeprom as configuration device. This is standard mic rochip device. However i want to use 1024Kb (24AA1026-I/SN) which has only to pins to configure the address. Will fx3 still be able to recognize this device? 2.) Since i will use only i2c for configuration, what should i do with pins for uart, i2s, spi, jtag ... should i connect them to ground or leave floating? thank you   
0 Likes
3 Replies
Anonymous
Not applicable

Hi,

   

Please look at this    

   

The I2S, UART etc are not configured so by default. If you're not using them you'll be configuring them as GPIOs so it depends on how you configure them in your firmware

   

Regards,

   

Anand

0 Likes
Anonymous
Not applicable
        In this case can i just leave them unconnected/floating? What about jtag?   
0 Likes
Anonymous
Not applicable

Yes, All unused pins can be left unconnected/floating (including JTAG pins).

0 Likes