- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I get this error message but can't find the net in question. Is there a way to find this net?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Jack,
If you double-click on the errormessage the net in question is (normally) highlighted.
If all fails, you may upload your project here to have us look at it. To do so:
Build -> Clean Project
File -> Create Workspace Bundle (minimal)
and then upload the generated Zip-file here.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Jack,
If you double-click on the errormessage the net in question is (normally) highlighted.
If all fails, you may upload your project here to have us look at it. To do so:
Build -> Clean Project
File -> Create Workspace Bundle (minimal)
and then upload the generated Zip-file here.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Found it. It was a stray wire that got left behind when I cleaned up the schematic. It was light green and short so I didn't notice it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jack, are you using the latest Creator 2.0 CP1? I thought that this annoying "feature" of checking for tangeling wires dissapeared in the last update.
To check, start the Cypress update-manager and let it check for updates.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have this in Creator 3.3 CP3. Double-clicking the error doesn't go anywhere.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You probably need to re-create the project.
Use Copy and paste from original to new project for topdesign pages and your self-written .h and .c files.
I would additionally suggest to create a workspace bundle from original project and send that for analysis to Cypres. Create a support case (At top of this page -> Design Support -> Create a support case) and attach the archive to the error description.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Restarting the program fixed it, but the bug still exists.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It is the latest 2.0. The wire was just hanging out in a blank area of the sheet.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Just had the same in PSoC Creator 4.0. Thanks for the tip on checking outside the canvas.
I was already going crazy after having rerouted it all.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using Psoc Creator 4.2 and had same problem. Don't panic. I just closed Psoc creator and rebooted my computer and opened the project again then no such issue was found again at all. I don't know what exact action fixed it. But give it a try.