- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I need to develop a USB3.0 system to transfer bulk data from FPGA to PC. Now I have the CYUSB3KIT-001 evaluation board and the Ulink2 (from Keil).Could I use the Ulink2 as the JTAG debugger to debug codes? Where can I download the driver?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I don't know the exact answer to your question. But I can point you to a document which has mentioned all the steps on how to use Seggar Jlink Probe with FX3 for debugging. Please refer to 12th chapter in the FX3 progammers manual.
Thanks,
sai krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, sai krishna,
Thank you for your reply. I also noticed the information to degug codes with JTAG from Segger. At present, I have a ULINK2 in hand, which supports the ARM9 processors. If it is possible, I want to make full use of the hardware.
Best,
Lehua Chen